REV date: 02-Aug-2017 11:09:03

MOBY262 data check

The intial check of the MOBY262 data before the satellite weighted data is put in the gold dir. There are two primary graphs below. The first data set plotted remove the earthsun distance, cosine response error (Ken) and solar zenith angle (using Ken cor#2 V04). Because we have adjusted the data for the solar zenith angle it is no longer neccisary to plot each hour separatly. So all the hour data are on one graph for each sensor and band. The second set of graphs just plot the data Lu or Es with no correction. So there are hour files. But if they time the hour files are collected change then the data will not match up very well with the mean and std data.

Most current plots using Ken Cor#2 V04 from the trends webpage. For these graphs the hour files are not separated because we have accounted for the zenith angle and other factors. This also means all the hour files are used for the mean and std giving a better estimate. The legend have the good, bad and questionable files from the current deployment as colored circles. The cyan are the last 4-6 deployments so you can see data points for current data. Note the 412 nm data for newer deployments will be high compared to the mean and std because the older deployments using a different stray light correction which makes the UV lower. Since the average uses all deployments whic will make the UV data look low compared to the mean.

Lu lw1
Lu lw7
Lu lw2
Es lw1
Es lw7
Es lw2
Lw lw1
Lw lw7
Lw lw2

Original plots of the data by MOBY hour Note this is the first time in a long time we have had a 00 hour file so there are no averages for this data or other deployments (close in time) to compare the 00 hour data too. So the graphs will look quite different.

In the legends "last 3" refers to the last three deployments of data. So you can see the were the data falls compared to other MOBY data.

Lu lw1 20 hour Lu lw1 22 hour Lu lw1 23 hour
Lu lw7 20 hour Lu lw7 22 hour Lu lw7 23 hour
Lu lw2 20 hour Lu lw2 22 hour Lu lw2 23 hour
Es lw1 20 hour Es lw1 22 hour Es lw1 23 hour
Es lw7 20 hour Es lw7 22 hour Es lw7 23 hour
Es lw2 20 hour Es lw2 22 hour Es lw2 23 hour

So the Lu shown under Lw1 is the LuTop data and the Es shown under Lw1 is the Es for the LuTop data. Ditto for Lw7 and LuMid.

Below the Lu/Es graphs there are the plots showing the ratio of the red spec to the blue spec for Es and Ed data. This is the correction applied to the Es and Ed data to correct for the sticky RSG shutter.

Below the Lu/Es graphs there are the blue red offset graphs so this can be monitored during the deployment. The graphs are by hour and sensor (Es, Ed and Lu) and show the previous 4 deployemnts for reference.


Lu_lw1

Figure 1

Figure 2

Figure 3

Figure 4

Figure 5

Figure 6


Es_lw1

Figure 1

Figure 2

Figure 3

Figure 4

Figure 5

Figure 6

Figure 7


Lw_lw1

Figure 1

Figure 2

Figure 3

Figure 4

Figure 5

Figure 6


Lu_lw7

Figure 1

Figure 2

Figure 3

Figure 4

Figure 5

Figure 6


Es_lw7

Figure 1

Figure 2

Figure 3

Figure 4

Figure 5

Figure 6

Figure 7


Lw_lw7

Figure 1

Figure 2

Figure 3

Figure 4

Figure 5

Figure 6


Lu_lw2

Figure 1

Figure 2

Figure 3

Figure 4

Figure 5

Figure 6


Es_lw2

Figure 1

Figure 2

Figure 3

Figure 4

Figure 5

Figure 6

Figure 7


Lw_lw2

Figure 1

Figure 2

Figure 3

Figure 4

Figure 5

Figure 6


Lu_lw1_hr20

Figure 1

Figure 2

Figure 3

Figure 4

Figure 5

Figure 6


Es_lw1_hr20

Figure 1

Figure 2

Figure 3

Figure 4

Figure 5

Figure 6

Figure 7


Lu_lw7_hr20

Figure 1

Figure 2

Figure 3

Figure 4

Figure 5

Figure 6


Es_lw7_hr20

Figure 1

Figure 2

Figure 3

Figure 4

Figure 5

Figure 6

Figure 7


Lu_lw2_hr20

Figure 1

Figure 2

Figure 3

Figure 4

Figure 5

Figure 6


Es_lw2_hr20

Figure 1

Figure 2

Figure 3

Figure 4

Figure 5

Figure 6

Figure 7


Lu_lw1_hr22

Figure 1

Figure 2

Figure 3

Figure 4

Figure 5

Figure 6


Es_lw1_hr22

Figure 1

Figure 2

Figure 3

Figure 4

Figure 5

Figure 6

Figure 7


Lu_lw7_hr22

Figure 1

Figure 2

Figure 3

Figure 4

Figure 5

Figure 6


Es_lw7_hr22

Figure 1

Figure 2

Figure 3

Figure 4

Figure 5

Figure 6

Figure 7


Lu_lw2_hr22

Figure 1

Figure 2

Figure 3

Figure 4

Figure 5

Figure 6


Es_lw2_hr22

Figure 1

Figure 2

Figure 3

Figure 4

Figure 5

Figure 6

Figure 7


Lu_lw1_hr23

Figure 1

Figure 2

Figure 3

Figure 4

Figure 5

Figure 6


Es_lw1_hr23

Figure 1

Figure 2

Figure 3

Figure 4

Figure 5

Figure 6

Figure 7


Lu_lw7_hr23

Figure 1

Figure 2

Figure 3

Figure 4

Figure 5

Figure 6


Es_lw7_hr23

Figure 1

Figure 2

Figure 3

Figure 4

Figure 5

Figure 6

Figure 7


Lu_lw2_hr23

Figure 1

Figure 2

Figure 3

Figure 4

Figure 5

Figure 6


Es_lw2_hr23

Figure 1

Figure 2

Figure 3

Figure 4

Figure 5

Figure 6

Figure 7



Ratio to correct the RSG sticky shutter for MOBY260


Figure 1B

Figure 2B


Blue red offset graphs for the 4 deployments before the current deployment


Figure 1B

Figure 2B

Figure 3B

Figure 4B

Figure 5B

Figure 6B

Figure 7B

Figure 8B

Figure 9B


REV date: 02-Aug-2017 11:09:03